I must've gotten a hot running e6300...

Lyquist

2[H]4U
Joined
Aug 21, 2004
Messages
3,368
I recently bought an Arctic Cooling hsf and temps are still low 50's while running folding@home. They are a little higher running Orthos for 24 hours. I guess I just got a hot running chip. I was hoping for somewhere in the 40's under load. Oh well. Anyone else with this chip and same cooler?? Thanks in advance.
 
First of all, we cannot give a clear answer with so little details... Please put the setup in your sig or list it here, including what cpu voltage and speed.
 
Poor HSF contact?
bad IHS?

Improper HSF installation?

Too much paste?

Crappy paste?
 
Here are my system specs...

e6300 @ 2.8GHz Stock voltage
Patriot DDR2-667 @ 800 at 2.1Volts
Stock northbridge (my fan won't fit with this big hsf)
Stock southbridge heatsink with a fan taped to it
Gigabyte DS3 rev 1 400 x 7
Arctic Cooling Freezer 7 Pro CPU Cooler
ATI X1600Pro Video Card
Three M-Audio soundcards
etc...

That should be the relevant information. All voltages except memory are at stock. When I left my memory at default voltage and overclocked it to 800, I got my first and only blue screen.

I think my hsf is seated properly, and I'm using Arctic Silver Ceramique paste...not the best, but it's better than nothing.

That's all I can think of right now. I am going to buy a smaller 40mm fan to put on my northbridge. My current fan won't fit anymore once I removed the stock hsf and put the AC7 in. My temps have gone down a few degrees, but I was expecting a little bit more based on what other people have reported.
 
I'd be happy with those temps, they seem pretty decent. Mine is 68C full load (e6400), with stock cooler. Getting a new heatsink soonish though.
 
It is 24 hours Orthos Blend stable, so I'm not complaining at all. I was just hoping for somewhere in the 40's under load.
 
you are dreaming if you are hoping for 40 or less under load... It's a pretty decent temp.

I was getting 54-55 in CoreTemp at 3.3 GHz but TAT is showing 68-70C. However, for this speed, i cannot complaint.
 
Those temps are good for aircooling assuming those are taken with CoreTemp.

my temps @ 3Ghz with a Scythe Infinity (one of the best air coolers) is still in the high 50C's with Orthos.

On a side note, with the DS3, if you leave your vcore (cpu) voltage on "Auto" ("stock") it actually overvolts the chips (some say as much as 1.45v!).

So you really should manually set the voltage to something like 1.35 and then test for stability.

If it still runs stable at 2.8Ghz you may want to lower the voltage some, (one notch at a time then retest). If its not stable, the raise it one notch at a time, until it is.
 
It's stable like it is, and I am using TAT to get the temperatures. It is now hovering in the low 50's with folding@home running on each core.
 
thats pretty good.

My set up @ 3Ghz with 1.39v hits like 58C with Orthos running. (ambient around 75F +-)
 
You shouldn't be complaining, 50 load is a good temperature. If you want 40's, get watercooling or open a window and let the room temp drop.
 
Back
Top