i just did something stupid last night

Joined
Apr 17, 2004
Messages
712
well this is sort of a long story but here it goes...

I was checking the innards of my comp last night while it was on( i wish i didnt do that : :mad: ) and i couldnt find my flashlight so i just used a light-up pen, and then i accidently moved the pen a little close to my heatsink fan's blades causing the fan to completely stop. I turned off my comp immiediately and took off the fan to find out that one of the fan's blades was broken and caused the fan to jam itself up, so i bent the broken fan blade off and put the fan back assuming that all is well again.. After that i turned the comp back on only to find out that the fan is causing a really bad vibration and it made my whole case vibrate. and the heatsink has an even worse case of vibration. But, the broken fan blade didnt seem to affect my cpu temps or the comp at all. i have a few questions reguarding this.

this is what my hs/ fan looks like http://www.svc.com/fd1270259b-21.html

1) So can anyone help me figure out whats wrong? I assume that after i took that fan blade off it caused the fan to act wierd.
2) Also, will the fan's vibrations cause my heatsink to pop off or something? I have a socket A hs if that helps.
3) Is it possible for me to continue using the fan or is it completely necessary to get a new one?

Any help will be appreciated :)
 
I think its vibrating because the fan's weight isn't evenly spread

I had a fan once that one of the blades were bent(a regular fan, not cpu) and wherever I put it it would jostle and vibrate

I think when you bent it you threw off alignment(which would cause vibrations) and when you broke it off you made it uneven kind of deal
 
I think its vibrating because the fan's weight isn't evenly spread

Bingo. That's exactly how you create a vibrating motor (like the ones found in cell phones). You put an asymmetrical weight on the end of the shaft, and it wobbles back & forth really fast when the motor spins.

3) Is it possible for me to continue using the fan or is it completely necessary to get a new one?

I'd replace it ASAP. They aren't that expensive, and who knows what kind of damage the vibrations might cause.
 
Aye. A similar effect happens to CDs when they're slightly bent or broken, causing them not to have an even and horizontal spin.
 
well i guess ill try to get the 70mm fan but i have a question....do 70mm fans use smaller mounting screws than 80/120mm fans?
 
I'd replace it ASAP, odds are the uneven weight will likely cause the motor to burn out quickly, and the last thing you want is NO fan. I'm sure the fan is going to be a lot cheaper than your cpu ;)
 
ok guys, i guess i solved this problem i looked up my broken fan's model number and found a fan similar to it and bought this fan to replace my broken one http://www.svc.com/60x15mmyounl.html
well..i sure learned my lesson....again..never poke around your comp's innards while its on.
 
Back
Top