Huge temp disparity between idle and load

RiverRed

n00b
Joined
Nov 1, 2006
Messages
41
I got myself a zalman 9700 and it idles @ 44 & loads @ 64.
My setup is a E6400 (29A) + 965P-S3 @ 1.4v.

I was worried about the 20 degrees diff and decided to reseat the HSF (and also check if the ISH is concave), but everything looks normal. Upon reseating it, my idle was 52 initially, 50 after the zalman grease cured abit (sigh, shouldn't have touched it).

Question is, is it common to have such a huge difference between idle and load temps ?
Thanks in advance.
 
If you're idling at 50c you're getting wayyy too hot.

Reseat it, especially if it was idling at 44 previously.

Also, what's your clockspeed? Those chips take about 1.3v (not 1.4v) at stock speeds.
 
I'm trying to get it stable at 3.4Ghz first before i try to gun for the magic 3.6Ghz.

According to the mobo, 1.325v is my stock voltage, but i can undervolt to 1.3 when i'm doing 3.2Ghz. At 3.4Ghz it seems to need a big jump to 1.4 to be stabler (i say stabler because orthos craps out after 4 hours ... probably because i ran 2xorthos instead of 2xprime by mistake)
 
sorry i only read the first half, idling at 44c and loaded at 64c isnt uncommon for air cooling when moderately overclocked. but 50-52 idle, yea that isnt good. my temps usualy fluctuate 20 or so degrees C between idle and load. also get yourself some arctic silver. youl use it once and never use anything else again.
 
I'm using the zalman STG-1 that came with the 9700 cooler.
It's meant to be on par with AS5 according to most reviews - some even had better results than the AS5.

But it's reliving to know that 20 degree is a common fluctuation - also feeling stupid for reseating it now. Perhaps 3 times lucky ?
 
Back
Top