HP SAS Expander Problem

B

boydjd

n00b
Joined
Jan 20, 2011
Messages
15
I'm having a problem where my SAS expander is appearing, however, none of the disks connected to it are showing up. I have the following configuration:

(2) Supermicro AOC-USAS-L8i cards, connected to 15 drives
LSI 1068E card flashed to IT mode
(2) HP SAS Expanders, in separate cases, connected to the 1068E. These are powered by a PCMIG card.

I have 5 drives connected to one of the SAS expanders, however, none of them are showing up!

I have attached the output of camcontrol below.

Does anyone have any suggestions on why this might be happening? Rescanning scbus2 doesn't make the drives show up either. :(

foghornleghorn# camcontrol devlist
<ATA ST31000528AS CC38> at scbus0 target 0 lun 0 (da8,pass0)
<ATA Hitachi HDS72101 A39C> at scbus0 target 1 lun 0 (da9,pass1)
<ATA SAMSUNG HD103SJ 00E4> at scbus0 target 2 lun 0 (da10,pass2)
<ATA SAMSUNG HD103SJ 00E4> at scbus0 target 3 lun 0 (da11,pass3)
<ATA Hitachi HDS72101 A39C> at scbus0 target 4 lun 0 (da12,pass4)
<ATA SAMSUNG HD103SI 1118> at scbus0 target 5 lun 0 (da13,pass5)
<ATA SAMSUNG HD103SI 1118> at scbus0 target 6 lun 0 (da14,pass6)
<ATA Hitachi HDS5C302 A580> at scbus1 target 0 lun 0 (da0,pass7)
<ATA Hitachi HDS5C302 A580> at scbus1 target 1 lun 0 (da1,pass8)
<ATA Hitachi HDS5C302 A580> at scbus1 target 2 lun 0 (da2,pass9)
<ATA Hitachi HDS5C302 A580> at scbus1 target 3 lun 0 (da3,pass10)
<ATA Hitachi HDS5C302 A580> at scbus1 target 4 lun 0 (da4,pass11)
<ATA SAMSUNG HD103SI 1118> at scbus1 target 5 lun 0 (da5,pass12)
<ATA SAMSUNG HD103SI 1118> at scbus1 target 6 lun 0 (da6,pass13)
<ATA SAMSUNG HD103SI 1118> at scbus1 target 7 lun 0 (da7,pass14)
<HP HP SAS EXP Card 2.06> at scbus2 target 80 lun 0 (pass15)
 
You must log in or register to reply here.
Back
Top