• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

hp netraid-2m (lsi e1600 oem) continuously beeps

J

jarthel

Limp Gawd
Joined
Apr 24, 2001
Messages
371
after booting the pc, the card continuously beeps. there is no drive connected to the card. during the boot process, i pressed ctrl-m to bring up the utility but it just goes on and the beep sounds after that.

i'm not really familiar with scsi and my only experience using it was thru an adaptec 29160n which booted fine even without the drive.

since this was a used card, i was thinking maybe the card is looking the previous drives connected to it?

I searched here and in google without much luck. i have downloaded the hardware guide from lsi's website still can't find any solution.

tnx

edit: i've found the audible warnings section. I still don't understand it though.
 
Link to manual? I can't narrow down what an e1600 is enough to get a manual...
 
jarthel said:
Since this was a used card, i was thinking maybe the card is looking the previous drives connected to it?
Click to expand...

Most likely ...

You should be able to enter the Configuration Utility, by pressing <CTRL><M> during boot, and clear the current configuration settings. If not, check your BIOS settings and make sure that Int19 is enabled ... check the jumpers on the controller to make sure that its BIOS is enabled ... or, grab the DOS based configuration utility off LSIs website.
 
You must log in or register to reply here.
Back
Top