HP Kayak XU800 CPU probs

BosHaus

n00b
Joined
Jun 12, 2003
Messages
11
I got a Kayak XU800 from my dad's work for like $25. it came with with a 600MHz P3. I figured, I could get a couple P3s cheap and make it pretty fast, so I hopped on newegg and got a couple of 1.1GHz P3s. I tried putting one of the P3s on (through a slocket) and when I power up the comp, it powers on (fans go, HD/CDRoms power up), but it won't boot. The front LCD still displays that its a 600MHz CPU even though I've pulled the battery out for hours and flipped the clear CMOS switch. It supposedly autodetects. The front LCD also puts little :) signifying the CPUs and everything passed POST. Does anyone have any suggestions on getting this working?
 
Did you verify that it will handle those processors? My guess is it will only handle 100 Mhz CPUs. Our PCs are standard parts, so upgrades are always possible, but if it can't handle those procs, then it's not going to work.
 
I put on the latest BIOS and still its still not working. I also tried swapping out the slockets. Does anyone have any other ideas?
 
Firstly, if it only did 100 FSB CPUs, it should still work, just it would be running the CPUs at a MUCH slower rate than it should. Eg, same multiplier & vcore, but lower FSB and at such a low speed something like that makes a huge difference. Still, it should be fast enough to boot up (run a modern CPU too slowly and it is highly unstable for some reason, but it's hard to get one that slow anyway.)

Anyway, that said, don't worry about the LCD. The last time I had a case that used that, the LCD display was controlled by setting some jumpers on the back of it and really had nothing to do with the MB/CPU. It was just for looks.

What I'm mainly wondering is if the MB itself can handle the slocket. I've heard people saying that some of them just can't seem to handle it. I'll admit to you though that I never messed around with that. I just had the same CPU the board was designed for back then.
 
Back
Top