How to setup RAID 1 on IP35 Pro

techguy101

n00b
Joined
Jan 14, 2009
Messages
62
Hi,

My current setup is Windows XP Pro 32-Bit on and Abit IP35Pro Motherboard. There is a 500GB SATA already connected that I have been using for the past while.

I Have just bought 2 WD 1TB drives that I would like to put in RAID 1.

How exaclty do I do this?

I haven't had much luck with google. But from what I gather there needs to be some drivers installed to windows.

I'm not really sure but I think there is two RAID controllers on the board. A JMicron and an Intel controller.I would like to use the intel.

Has anybody done RAID on this board?

Any advice? I'm stumped!!

Thanks..
 
Yes, That board has two SATA controllers ...
Channels 1-4 are one and 5-6 are the secondary

Go into the BIOS, and it will let you enable the RAID. by default it is set to IDE mode on the SATA.

Once enabled, just install the drivers for that RAID driver off the CD or "The Net".
 
I had a similar scenario. Once you enable raid on the motherboard and try to boot up you will get a BSOD because the drive mode has changed. Installing the raid drivers before hand never really worked but there is a way. Easy way to get around it is connect your boot drive to the eSata port on the back of the motherboard via Sata to eSata cable. then change your drive mode to Raid, install new drivers for raid and then reconnect your boot drive back how it was along with your raid 1 set. There are lots of articles about set up raid like you have it.
 
Oh No!!

I don't have an eSata to Sata cable.

Let me get this straight, to use Windows with a raid controller it must have drivers installed or else windows will crash any time it sees a raid controller. Thats why it gives you the option at the very beginning of every windows install.

I wonder is there any alternatives to the eSata solution..I'm going to try googling that..

Keep the suggestions coming..

Thanks guys!
 
Ok... here is where i'm at so far. (Not Much btw)

I have installed the two 1TB drives to the first two sata ports on the MB.

I've decided that I am going to slipstream the drivers(from the intel floppy utility) into a windows setup and burn to disc. Enable RAID mode in the BIOS and then run the windows setup again - on the exisitng windows install.

Will this install the drivers for me..

Just to be safe I am curently formatting one of the new drives and I will copy everything to that before the windows setup commences..

What do you guys think of that plan? Should it work?

Anything I should know?

--Thanks..
 
I am actually completely lost here!!

I just used nlite to slipstream some drivers into a windows install and then ran the install hitting r to repair the current install..I did this with RAID enabled in the BIOS..it didn't work, I got the BSOD shortly after.

I'm not even sure I used the correct drivers in my last windows repair session, the intel site isn't very clear.

I've tried searching for ICH9R with no results..bummer!!
Where do I go to find the proper drivers?


What to do, what to try next??
 
You could try to install the raid drivers and then image the os. I didn't have any luck doing that friday when I set up a new raid. There is also this registry edit from ms you could try.
http://support.microsoft.com/kb/922976

I just found it easier to backup my old stuff and copy it back onto the raid after I did a fresh install.
 
Back
Top