How to partition XP RAID 0 array to install Vista?

Camaroz06

Gawd
Joined
Jan 26, 2007
Messages
642
Hi All,
Quick question, I have a RAID 0 array (2x74gb raptors) that is a single partition and now I want to install a copy of Vista to the array. How do I go about partitioning the RAID 0 array to install Vista? I tried gparted but it couldnt see the array, it just saw two seperate drives. Anyone know what to do?

Thanks,
Eddie
 
Did you set up your raid array in the raid bios?

Once you do that, the 2 drives should only show up as one.
 
Yup, they are all set up. I already have XP installed, but I cannot figure out how to partition the RAID 0 array, well I have only tried ot use gparted. Anyone know some partition software that can partition a RIAD 0 array? Is there a free way to do it?
 
good question

Just report this guy for spamming the site with mindless posts to pad his post count so he can post to the FS/FT section. Hopefully the ban hammer will come down and settle this.
 
Gparted saw the single partitioned RAID 0 as 2 seperate drives and it wouldnt let me work with them :(

Seriously that is kind of hard to believe??

What board are you using?
Are you using a dedicated controller? if so which one?
 
If you have vista business or ultimate edition can't you just setup raid 0 via software raid, i could've swore i saw that option when installing vista from a clean install. But otherwise you might have a driver issue or something that is causing the problem
 
Whats a "good" RAID card cost, cheaper the better. Anyone have one they love? I will be running Vista 64 on a newer 750i board.
 
Well, if you do get a new standalone RAID card, you will have to redo the array. That being the case, and you dont actually mind the onboard NVRAID, you might aswell just wipe your current RAID0 and make two partitions.
 
I dont mind the onboard so much. Since I am starting over anyways is this how I would go about setting up 2 partitions when installing XP again, when I get to the during XP setup do I just allow XP to partition 1/2 of the RAID 0 array?
 
I dont mind the onboard so much. Since I am starting over anyways is this how I would go about setting up 2 partitions when installing XP again, when I get to the during XP setup do I just allow XP to partition 1/2 of the RAID 0 array?

Yep, just create 2 NTFS partitions in whatever size you want. Make them both NTFS, install XP on one, and Vista on another.
 
Back
Top