How to hide some wires? Small wire clips?

Kaizer

Gawd
Joined
Jul 9, 2001
Messages
737
Basically the wires inside my computer are a mess at times. Wires need to be tucked away and routed. One problem I kept running into was places to tuck the wires so they would be out of the way. Case fans in particular seem to be the hardest to manage, especially the one in the window of the pc. I need to come up with a good way to route that wire.

The only thing I can think of to use are those wire clips that have that sticky backing on them so they can be mounted to what ever. My problem has been trying to locate some SMALL ones that would work with the tiny fan wires. Has anyone found a good source for them? I can find the larger ones.. but I need some that are as small as possible.
 
I've had good experiences using double-sided foam mounting tape and scotch tape in tandom to keep stray wires in check. Cut some mounting tape to small strips and stick the wire to that, then put a little scotch tape over that to ensure it won't come loose. You can cut both those pretty small and hide them just about anywhere.
 
I may have to try that.. I dont think mounting tape will help much with the window fan though.
 
Unless your window fan has a really long cord, it's best to leave it dangling, otherwise you have trouble opening up your case later. What brand and model case do you have?
 
I hide my Wires:

Behind Mobo Tray
In Drive Bays
Above PSU
Out back of the case
With the window Fan Wire, I just sleeved it black, you can hardly see it unless the UV's are on

:) :) :)
 
Here's an idea. Considering the placement of the window fan, how about this...

First, to extend the wire, find some small guage wire (you can buy some from radio shack fairly cheap) and cut two or three lengths of it about 10-12 inches depending on how long you want to extend your fan wire. Snip the cable right by the connector plug and tear off the heat-shrink tubing to expose the plug's pins, making sure to memorize which colors go to which pins. Strip both ends of your fresh wire about 1cm, maybe a little less. Solder the wires to their respective pins making sure to place a little heatshrink tubing over them after you're done. Then, slip about 1cm of heatshrink over each wire and strip the ends of the fan wire. Solder the wires together, remembering to match the colors of the fan wire to their proper pins, and then cover the bare wire with the heatshrink you slipped over the wires before.

Whether you extend the wire or not, you can try doing this to route it. Take a pencil and a blow dryer(optional). Wrap the 8-9" of wire closest to the fan in a tight coil around the pencil. Hold it there for about 2 minutes while blowing hot air over it with a blow dryer. The dryer is optional, but I've found that it helps. Once that's done, you'll have a nice flexible coil of wire coming from your fan. Attach the wire just past the coil to your case using the mounting tape method mentioned above and route around the motherboard. (You'll probably have to extend the wires for this.) This will leave only the coil visible and that coil should allow for enough flexibility to easily remove and replace the side panel.
 
Back
Top