How to clear all interface commands on cisco equipment?

[cyr0n_k0r]

I do not want to clear the interface statistics, that is easy.
I am trying to figure out if there is a command that would essentially remove any and all configuration commands for an interface so you wouldn't have to issue "no" commands 7 or 8 times to get the interface back to a blank slate.

Does such a command exist?

IE:

FastEthernet 0/1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan 1,10
switchport voice vlan 100
switchport mode trunk extend cos 3

to reset to

FastEthernet 0/1
no ip address

 

[Arch]

def int f0/1

 

[Captain Colonoscopy]

swith(config) default interface fa0/1

that's it
Posted via [H] Mobile Device

 

[berky]

write erase?


j/k... don't do that.

 

[Lightworker]

default int range fa0/1-48

 

[cyr0n_k0r]

AWESOME.
Thanks so much.