How many things can go wrong with a printer?

Joined
Jan 25, 2005
Messages
3,026
I got an Epson C86 with my computer a few years ago which is part of epson's infamous line of failing printers (C82,C84, C88). There is, consequentially, a lot of discussions online of people who have noticed their printer no longer prints anything to the page. The common solution has been to clean the ink vacuum tube thing, but I did that just last night and it didn't help. What else could be wrong, on a typical level?

I do at least have a replacement printer from Epson.
 
I wanted to make sure I understand the problem... there are HUNDREDS of things that could go wrong with the printer, but only a few for each type of symptom. From what I'm reading into your error is:
the printer acts like its printing, moves paper normally, runs the printhead over the paper normally, but the paper has nothing on it, no error codes or lights on printer.

This could be caused by -
-bad or clogged printhead - epsons historically have a permanent head that is very hard to replace - get it serviced or replace the printer. If your printer sits for long periods of time (a week or more) in between printing, I'd HIGHLY suggest buying a printer that has its print head built into the ink cartriage.. the ink will be more expensive, but you're whole printer won't have to be replaced when ink drys inside of the printhead.
-ink supply to printhead is clogged or empty - guessing this is the tube you cleared
-electrical problem - cable which runs to printhead is damaged or disconnected. Logic boards sending signals to the printhead is damaged/not sending signals. - least likely problem - printer would have to be serviced by someone who knows the model and/or replaced with a new model.
 
I'm assuming it is a clogged head, but what's getting me is: for everyone else, a simple fix of the head cleaner system did the trick. I fixed that part, but it was unsuccessful at unclogging the nozzles or something of the sort.
I picked this printer back up as a mere past time, so I give extra thanks.
I'm assuming there is no way to send something through the nozzles without the consent of the printer? I wouldn't say there is a break in any cable as it can determine my ink levels at least.

Only cyan and blue are printing currently, and not at their highest quality either.
 
My brother had luck soaking an epson printhead in a high concentration of alchohol - I think he used a rubbermaid type of container so the alchohol wouldn't evaporate leaving only water behind.

if you try this, make sure you give the head enough time to dry completely before attempting to install/use the head again. Other than that, you MAY be able to find a replacement head for your printer.
 
Back
Top