• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

How is PPD calculated

S

sachem87184

[H]ard|Gawd
2FA
Joined
Nov 6, 2007
Messages
1,593
I was always curious as to how it works, I have 2 e4300 on the SMP clients and FAHmon tells me that I'm only doing 350-400PPD.
 
It extrapolates it based on the point value of the current units your clients are working on and the average time it takes to complete each frame. Basically, it's: Σ{[(minutes in a day)/(minutes per frame)]/(100 frames/workunit)}*(point value of current unit), where the Σ means that you perform the above algorithm for each client and add them all together to find your total PPD.

350-400PPD does seem extremely low though; I have a Pentium D running at 3GHz that puts out about 700PPD on average, and you should be doing a fair bit better than that. Do you have the clients set up properly on both systems?
 
If they are running at stock clocks , E4300=1.8GHz, it doesn't seem that far off. The WinSMP client I'm guessing?
 
Something is not right there.

My Dell Vostro with C2D 1.4Ghz (2 MB Cache) could do 600 PPD with winSMP.
 
as always it depends on which work units you get. I have an e6300 running winsmp and it only gets around ~500ppd. Which is the same as if I was running 2 x uniprocessor clients.
 
You must log in or register to reply here.
Back
Top