hotswap/wrong bios..Fried motherboard?

hbidad

Gawd
2FA
Joined
May 8, 2002
Messages
841
Hey guys, I was doing a the hotswap trick in a kt400 board.

I boot to dos...swap the bios chip...flash the chip and power down.

I had company over and forgot about the wrong bios in the motherboard. Not thinking, I powered on the system and it took me to the Setup screen. I go and set my FSB to 133 ..save and reboot. Powered up but no post. I then remembered that I forgot to swap out chips. I then powered off and replaced the chip...No go..I then used the kt3 board to hotswap and reflash the kt4 bios chip with the same bios installed thinking it might be currputed.

Still nothing. could running the wrong bios fried the board? (btw I reset the cmos a few times)
 
What make/model of board?

Best thing to do is take the CMOS battery out for an hour or so, and ensure that if you have a 100/133/166 FSB jumper on the board, that for the moment, you set it back to the 100MHz setting. Clear the CMOS jumper once after that time, then put the battery back in and try it again with the correct BIOS chip installed. If this doesn't work, you probably have nothing to lose, so you could then try the same procedure with the wrong BIOS chip, though if it doesn't work with the right BIOS I doubt it will with the wrong one.
 
this is the MSI kt4 ultra. NAh, the board booted fine with the wrong bios chip. However, I changed a few settings and rebooted. Then it wouldn't post at all (no error beeps). That is when I realised that I hate the wrong ship installed. After that is when I installed the correct chip witht he same results. I was just curious to see if this will blow certain things that I could try to repair myself since I don't really have the money for another board for another week or so (just bought a 6800)
 
I've worked with a number of MSI boards...the solution I mentioned previously has worked on a few occasions, at least on the boards that had an FSB jumper on them (the symptoms you mention sound a lot like what happens when someone sets an incompatible FSB with a certain CPU or tries to overclock too far). Removing the battery to clear everything, and then resetting the board to all default jumper settings may indeed help. I don't know that you could blow anything, but you might be able to screw up e any programmable IC's that might be on the board.
 
Yea, That is what I was affraid of. I took the battery out and I will let it sit over night.
Hopefuly that will do something.
 
Back
Top