Home made fan duct

Dominat0r

2[H]4U
2FA
Joined
Jun 28, 2001
Messages
2,646
I was surfing and saw a review on this fan duct this. Basically we all know this, supposed to help create less of a dead spot from the hub of your fan.

I decided to try it and see for myself. I took a old 80mm fan and cut the fan out. I then took my trusty dremel and grinded the inside so it was nice and smooth on the inside. I kept the overall shape inside, so the fan will force the air towards the middle of the heatsink where the dead spot normally would be.

My heatsink is the Silent boost. I got a fan from a [H] member (thanks zeebs). Its a Sunon 45CFM (3500RPM), at 36db. I noticed that it was alot louder then anything in my case. After this was done, the vibration sound dropped a TON. I could no longer hear it over my Fan card. That alone impressed me.

I took the hollowed fan, attached it to the heatsink, then attach my Sunon to it using small zip ties. I used the Silent boost stock screws and just ran a small screwdriver right through the fan's screw holes.

End result is pretty good. I got a 2-3C drop on idle and 1-2C drop in load temps. Nothing to stop the press over, but hey it didnt cost me anything but time and a old 80mm fan.

Here is the finished result....seriously it performed alot better then i thought it would.

So, a old fan 0$, 4 zip ties 0$, 15mins 0$, for a 2-3C drop in temp, priceless.

DIYfanduct.JPG
 
That's damn cool. I was thinking about making a air duct for my processor but didn't know what to use. I've got a few 120mm fans laying around I'm not doing anything with maybe I'll take them apart then figure out how to mate the duct plus the fan to my XP-120. Thanks for the idea. I hope you don't mind me using it?

So here's what I started with, an old Muffin Mark 4 120mm x 1.5" fan (made by Rotron Incorporated, are these guys even still around?) to show you how old this thing is it's 115VAC 4W and it was a 50/60 Hz model fan. I tried taking the fan out without breaking anything but since it's so damn old and dry part of the housing (one of the screw holes) broke off, no biggie that side will go to the fan.

I was going to use a ETRI fan but when I took it out of the box it was in I found out that the case is made of metal which I think is too heavy to mount to my XP-120 (and it's not aluminum, it's steel)

I've got pics if you'd like to see them.
 
I dont mind at all man, thats why i posted it.....i thought as everyone else did, does it really work?

Well to me its working great. Im still impressed in the sound dampering it does. MAJOR difference in vibration sound.

Hope it works as well for you as it does for me.
 
Thanks. I haven't installed it yet. I need to hit it with the Dremel and fill in some of the areas that aren't going to seal well since it was such a large fan tehre are a few recesses in it that I need to fill in.

I couldn't tell in your pic but did you put the fan on top of it (fan - duct - HS) or underneath it (duct - fan - HS)?
 
Back
Top