• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Highpoint Hpt374 RAID controller help needed

T

Thomas Covenant

n00b
Joined
Sep 5, 2004
Messages
30
Is there any way to get the Hpt374 to use single drives in a non-raid array? I already have 2 drives on one of the four channels, so I know its is partly possible but I can't get my new 250 gb WD drive to work. Ive tried it on other channels on the controller and I've tried unhooking one of my current drives and replacing it with the 250 but no luck yet. Does it have to be formatted first? The strange thing is that the RAID Bios sees the drive but only when it is replacing one of the other drives. I can't just connect it to a channel alone and see it. Any ideas folks?
 
yes... easy... dont configure the drives as any arrays.

sounds like your problem is jumpering... jumper your drive as Cable Select. and make sure that your cables are good and support ata100/133.

Hope that helps.

Doctor X
 
You must log in or register to reply here.
Back
Top