help!!!!!!!!!!!!!!

suqmaster

Limp Gawd
Joined
Aug 21, 2004
Messages
156
I have a dfi motherboard and 1gb of crucial pc2700 memory. I changed the cas time to 2, tras to 2, trc to 2, and some other stuff. I didn't change the voltages or anything though. Now my computer doesn't even show a display so I can change it back in the bios. The compture just runs when I press the "on" butten but no screens or anything. The mouse and keyboard doensn't work either. I tried rearranging the memory sticks and replugging my power supply.........nothing works!!!!!!!!!!!!!! someone please help!!!!!!!!!!!!!!!!!! my specs should be listed below.
 
unplug the power and take out the cmos battery for a couple minutes and then put it back in. Then try it out.
 
There should be a jumper on your board to clear the CMOS. Read your manual and it should be in there. Unplug the power cable from the computer, clear CMOS, go into BIOS and set it up again and you should be up and going. Sometimes taking the battery out won't work (I've seen this happen before).

Lyquist
 
Yup what ^^^ they said. Unplug power supply from wall, pull jumper off CMOS count to 5 put it back on. This will reset ALL BIOS settings.

I thought I remember reading somewhere that pressing the insert key on booting would also reset the BIOS??

ThE sHaDoW
 
shadow-13x said:
Yup what ^^^ they said. Unplug power supply from wall, pull jumper off CMOS count to 5 put it back on. This will reset ALL BIOS settings.
I thought I remember reading somewhere that pressing the insert key on booting would also reset the BIOS??
ThE sHaDoW
I would wait longer than 5 seconds... try like 20 min cause power will be there for a little while after you shut it off...
 
I finally got this motherboard to work!!!!!! I was about to call the local computer repairman. Damn I need to get some new memory I can't oc anything with the ones I have
 
suqmaster said:
I finally got this motherboard to work!!!!!! I was about to call the local computer repairman. Damn I need to get some new memory I can't oc anything with the ones I have


LOL, that's probably because your memory already IS overclocked, if you're doing what your siggy claims, running DDR 333 at DDR 400 speeds...that's a 67 FSB increase on the stock speed of your memory. If you had DDR 400, you could be at a FSB of 467. :p

Me
 
Spike said:
I would wait longer than 5 seconds... try like 20 min cause power will be there for a little while after you shut it off...

It never took me more than a few seconds to reset my bios... especially if you follow the directions listed in your MB manual
 
Back
Top