Help me diagnose this problem

xSnip3rMaNx

Limp Gawd
Joined
Jan 8, 2007
Messages
248
ok heres the problem... my grandma has a emachine t2642 and it messed up. I replace the mother board with this and the PSU with this. i got the parts and installed them today. i go to turn it on and nothing.... no power at all no fans no led or anything. ive check all the connections 2-3 times now and cant figure it out .

any ideas as to why its not getting power?

thanks!
 
Ok might be stupid assumption but did you switch the power switch in the back?
 
Do you have the 4 pin power connector plugged in? Do you have the front panel leads wired correctly? Are you sure that there aren't any mobo standoffs sticking into the back of the motherboard causing a short? Have you tried unplugging every cable (IDE and power) except for the ones going to the motherboard?
 
power cord maybe :p
nope tried 3 diffrent ones


Ok might be stupid assumption but did you switch the power switch in the back?
nope of couse i checked it

Do you have the 4 pin power connector plugged in? Do you have the front panel leads wired correctly? Are you sure that there aren't any mobo standoffs sticking into the back of the motherboard causing a short? Have you tried unplugging every cable (IDE and power) except for the ones going to the motherboard?

tried everything you said still nothing. i even tried my PSU in it and still no power. so i guess i got a bad mobo or PSU from newegg??
 
haha i got it.... i was reading the reviews on newegg and people said the manual had the CMOS jumpers labled incorrectly. i just swithed it back to the way i got it and POWER!.

thanks for your replies though:D :D
 
well, if your PSU didn't work, it probably is the mobo. PCCHIPS used to have really bad DOA rates. I thought they improved over the years, but maybe they still have a problem.

/edit: that's awesome. heh.
 
Back
Top