Hello again all.
I'm taking on yet another project, one I couldn't resist after seeing the video below:
YouTube Link
After hunting around on the Evil Mas Scientist Laboratories website I found an example circuit diagram and building instructions.
I was hoping that someone could help me make some sense of the diagram below. Perhaps put it into lamens terms for me. I have a bit of hobbiest level electronics experience, but I've never taken on a project like this before.
Here is the circuit diagram, which I understand for the most part, I was just hoping someone could offer up a wiring diagram to help me better understand.
The project called for 16 of these circuits in a 1-D topology (whatever that means)
They took some pics of the circuit as well - simple enough, I just have a bit on confusion identifying which wires correspond with which:
When complete it should start to look something like this (hopefully I can do a better job of wire management).
Any help that you lot can offer would be a great benefit, I don't have much experience with making my own IC circuits... outside of some basic arduino projects.
Thanks in advance.
I'm taking on yet another project, one I couldn't resist after seeing the video below:
YouTube Link
After hunting around on the Evil Mas Scientist Laboratories website I found an example circuit diagram and building instructions.
I was hoping that someone could help me make some sense of the diagram below. Perhaps put it into lamens terms for me. I have a bit of hobbiest level electronics experience, but I've never taken on a project like this before.
Here is the circuit diagram, which I understand for the most part, I was just hoping someone could offer up a wiring diagram to help me better understand.
The project called for 16 of these circuits in a 1-D topology (whatever that means)
They took some pics of the circuit as well - simple enough, I just have a bit on confusion identifying which wires correspond with which:
When complete it should start to look something like this (hopefully I can do a better job of wire management).
Any help that you lot can offer would be a great benefit, I don't have much experience with making my own IC circuits... outside of some basic arduino projects.
Thanks in advance.