Help: Installing motherboard into a new case......

MadDog5145

Limp Gawd
Joined
Jul 2, 2004
Messages
142
I wanted to transplant the inards of my Compaq into a new case so I got the Centurion 5 case. Everything went fine until I looked at the power connectors (the ones that lead to the buttons to turn the computer on or reset it). I have no clue which order to put these guys in. I tried following the motherboards manual and the my computer is still isnt turning on.

Here is the motherboards manual's link:
www.ctechinfo.org/manuals/salmon_manual.pdf

Page 23 is what I was looking at.

Oh yeah I also got a nasty cut on my pinky from the case :eek: Not a good day so far hehe.....
 
The power switch should be pretty straight forward. Its just a switch that closes a circuit to ground, so it doesn't even have to be a plugged in a particular direction. Unlike the LED's which have to be plugged in a certain direction otherwise the LED won't light up.

The case should have a two wire lead coming from the power switch, probably labeled PWR or something like that, and you would plug it into that header on the motherboard. Plug it in to that it connects the pins PWR & GND

Are you using a power supply that came with the case or the original? You can verify the power supply works buy unplugging it from the wall and putting a paperclip or something similar across the GREEN wire and the BLACK wire right next to it on the Motherboard power connector. Then when you plug in the power supply it will think a motherboard is plugged in and telling it to turn on.

If you get it turn on, but you LED's don't work, just turn the connectors around and they should work.
 
Thanks that helped alot!

Is there any detailed manual for the Centurion 5? I can't figured out how to configure the front audio ports (can I even use the front audio ports with an Audigy ZS card?).....
 
Back
Top