Help - CRT Jitters with Vista

kilgore777

Gawd
Joined
Sep 12, 2005
Messages
896
Need some advice. I just got a new PC with Vista Home Premium. Hooked up my Sony Trinitron Multiscan E440 (19" CRT) and the entire screen has a consistent shake or jitter. It never stops and it does not change - it's not really bad, but annoying. When hooked up to my old PC (XP Home) - there is no issue. When in Safe Mode in Vista, there is no issue.

Any ideas? Could this be a driver issue? I have a EVGA 8800 GTX and have to use a converter for the CRT - could that be an issue?
 
Most likely interference. When you run Vista normally it is probably using a higher refresh rate than safe mode. Change your refresh rate around and find one that doesn't have the interference problems.
 
Yep - powerline interference. In safe mode the monitor refresh rate is set at 60hz which is the same frequency as 120V AC power lines in your home which is why there is no wobble or jitters in safe mode. Try rearranging any power cords near your monitor and trying different refresh rates. Here at my shop one of the computers is right beside a breaker box. Norefresh rates I tried could stop the jitters other than setting the refresh rate to 60hz or swapping the monitor out with an LCD monitor. Worst cases - run the monitor at 60hz or move the monitor.
 
In close proximity, my cell phone makes my CRT have this problem. WiFi might produce the same type of effect.
 
Yep - powerline interference. In safe mode the monitor refresh rate is set at 60hz which is the same frequency as 120V AC power lines in your home which is why there is no wobble or jitters in safe mode. Try rearranging any power cords near your monitor and trying different refresh rates. Here at my shop one of the computers is right beside a breaker box. Norefresh rates I tried could stop the jitters other than setting the refresh rate to 60hz or swapping the monitor out with an LCD monitor. Worst cases - run the monitor at 60hz or move the monitor.
Gonna have to agree, i'd bet money that you are correct.

OP something in that new computer is interfering with your monitor (powersupply?). You're going to have to hook them up to different outlets on different breakers. You could also try a different powersupply, or you could possibly try something like the triplite isobar. Not 100% sure the tripp lite isobar will work, but i'm pretty sure it would, and it's an item that would always come in handy elsewhere if need be...

let us know how it works out.
 
Thanks everyone for the suggestions. :)

I failed to mention that I did muck around with the refresh rates - to no avail. I am actually using an old Isobar Tripp Lite (maybe it's too old!). Also, I tried running a heavy duty extension cord from an outlet far away and plugging only the monitor there - it didn't help.

I just bought an APC 1500VA Battery Backup System - perhaps this will fix it. Haven't set it up yet.

Thanks again, I'll post again later on this....
 
Thanks everyone for the suggestions. :)

I failed to mention that I did muck around with the refresh rates - to no avail. I am actually using an old Isobar Tripp Lite (maybe it's too old!). Also, I tried running a heavy duty extension cord from an outlet far away and plugging only the monitor there - it didn't help.

I just bought an APC 1500VA Battery Backup System - perhaps this will fix it. Haven't set it up yet.

Thanks again, I'll post again later on this....
Hmm, as mentioned prior it may be originating from something power related (psu, wall outlet etc) or it could be originating from your video card, an impure vga signal that is, rarer but not unheard of.
 
Back
Top