Heatsink stuck to my CPU

c0ex

Gawd
Joined
Jun 13, 2005
Messages
764
I have a p4 2.8 GHZ chip that is stuck to a copper heatsink. Do you have any ideas on how to remove the heat sink? Also do I still need a fan if I am using a heatsink?
 
Yes you need a fan for a P4. If you don't already have one on there put one on then turn the computer on for a few minutes and let it get warmed up (shouldn't take too long).
Then power off the computer and take the heatsinkfan off, it should come off if the thermal paste or other thermal substance has been warmed up.
 
........... ..... ... .... For real?


I am assuming you released the clips for the heatsink to release it?

And yes you really do need a fan on your heatsink. I know that zalman makes a fanless model but your typicall heatsink needs a fan.
 
all, thx for the idea of heating it up. Also will freezing work? The p4 is coming off a laptop with a weird heatsink that appears to be stuck. I have another heatsink for the dsesktop that I plan on putting in which will work.
 
c0ex said:
all, thx for the idea of heating it up. Also will freezing work? The p4 is coming off a laptop with a weird heatsink that appears to be stuck. I have another heatsink for the dsesktop that I plan on putting in which will work.
no, heat it up, safest and easiest way to get it off
 
i have to oreo mine off, laptop and desktop, but they both bake the as5 to near-solidness
 
yea, i tried to freeze it, but it didnt work. I tried that rubbing alcohol and that didnt work. I was wondoring if the size of the heatsink matters?
 
c0ex said:
yea, i tried to freeze it, but it didnt work. I tried that rubbing alcohol and that didnt work. I was wondoring if the size of the heatsink matters?
oreo it, takes quite a bit of force, if its a thermal pad you might need to gently pry it off wih your finger nail, do not use a screw driver
 
another idea i seen on this forum, just take some thin fishing line and work it through the space between the cpu and heatsink to seperate them.

We are talking heatsink and not the IHS right ( just want to be careful)
 
This happened twice to me, with both of my p4 systems. One was a 2.4C and the other a Celeron D 2.4. I just used a screwdriver to carefully pry...I know it wasnt a smart idea but they work fine now.
 
That's funny, the only time this happens to me is with my 2.4 Celeron D. Every time that I remove the hsf, the cpu is stuck to it and comes right out of the socket.

I also have oreo'd the cpu loose. It will work, with minimal risk as long as you are careful not to bend pins. It would theoretically be easier if the hsf is warm, but it should work either way.
 
i got it off. whew. I let it heat up for 3 minutes and then i pulled it off. They used some type of gray glue!
 
Back
Top