HD not being seen at full size

[CyberSlave]

I have a 160 HD on a single RAID channell.

I am running Service Pack1 and my OS is fully updated.

I am only seeing 127gigs, not 160.
I have run both the enablers from Matxor, BigDrive evnabler, and MaxBlast.

Never ahd a problem before getting ti to see, but this time I am stumped.

WinXP Pro, fully patched
HD's:
40g
60g X2
80g
160g

All are seen fine except the 160.

 

[Ice Czar]

http://www.hardforum.com/showthread.php?p=1026129864#post1026129864

try searching that first link (48bitLBA.com)
Id think niether the DDOs would be required since it was on a RAID Channel which uses SCSI Drivers

 

[CyberSlave]

already done.

 

[compslckr]

did you try partition magic 8 on it? they have a free trial of it on their site


http://www.soft32.com/download_151.html

 

[CyberSlave]

nope. Still won't see the full size.

Everything I use says the drive will be 137g, not 160.

I am stumped.

 

[qpid]

Is it connected to an ata 100 controller? i had a similar problem and then when i connected it to my ata 133 controller it went away

 

[CyberSlave]

all better.

My onboard RAID didn't want to see the full drive for some reason.
Popped it on as a slave on my main IDE and it works like a champ again.


The easy solutions are often overlooked