Having troubles with NV5 Silencer

Shadow27

Gawd
Joined
Jan 14, 2005
Messages
646
Hey, I recently fitted a NV5 silencer to my new 6800GT. When i installed it all seemed to be good, the temps were a great improvement over the stock cooler and there was almost no noise anymore. I load up Splinter Cell Chaos Theory and I get artifacts, not bad but little blue dots on some textures. I exit and load up rthdribl to check load temps. 51c load, much better than stock and I notice no artifacts. I took the card out and i notice not all the ram modules are touching the cooler (using thermal pads that came with it). This is the revision 2 of the silencer so the base completely flat. Hmm, just for interests sake i take it all apart and remove the thermal pads for the ram to see how much gap there is. There is no way i could fill that gap with Arctic silver. So i put it all back together and clock back the ram to 900mhz instead of 1000mhz. That solves the issue. Not happy at this point. What should i do? Chaos Theory is the only game it does this in too.

I tried putting the stock cooler back on and it does the same thing. The problem is i didn't have this game installed before i put on the silencer so i don't know if it was doing the same thing with the stock cooler. I was looking at the Zalman copper cooler that comes with seperate ram sinks, has anyone used one and what were your temps like?

Thanks in advance
Shadow27
 
don't use thermal pads.. use only thermal grease on gpu and all RAM..

i once left thermal pads on the RAM, and that made the heatsink not be able to touch the GPU core. =\
 
The only thing is that there is quite a gap between the cooler and the ram modules. I dunno, its driving me nuts, I don't think i damaged the card at all, its just the small artifacting in Chaos Theory that only happens in like one or two spots all the time. Like on the ground a small patch of random blue/red dots aaargh. I ran rthdribl for an hour with atitool checking for artifacts and it showed nothing :confused: I ordered some more arctic silver after i ran out refitting the damn thing so many times plus some new thermal pads cause the old ones are more worn out than an old prosititute. I also ordered some arctic clean so its all clean once i start again. Blah, maybe i should order one of those Zalman coolers that have seperate ram sinks and fit em with arctic ceramique.

Shadow27 - urge to snap rising............. :p
 
I use ceramique on the ram and AS5 on the GPU
ceramique isn't conductive and has a little more body to it
But it can only fill so much!
 
I'm not sure how thick the NV5 plate is but my AS2 (i think, for my 9600xt) had the same problem, I had to use pliers and bend the plate so it just touched, then worked great.
 
Back
Top