Group policy not applying

iamkion132

n00b
Joined
Feb 27, 2007
Messages
57
Sorry if this is the wrong area for this but I'm having difficulty applying a group policy to a computer. The user logs in to this computer and none of the settings that the domain uses apply. I did a gpupdate to see if that helped at all but I got a 1030 error and another error as well every times that I did this. I wanted to make sure that the user wasn't having problems so I had them log onto another computer and the settings were applied correctly there.

On the computer that is having problems, they can access the network but they are prompted to log on before being allowed access. The machine that is having problems was just recently restored and I haven't installed any service packs yet, so I'm not entirely certain how that might influence anything

There were a couple of other small things that I checked but I don't think that they have anything to do this this. I did check with the network connections to see how the authentication was working and the settings is use 802.1X authentication and authenicate as computer and when I compared the working computer vs the non working one there is an option to use simple certificate selection that isn't an option on the non working computer.
 
You said that the computer was previously restored. I would delete the computer account from the domain, and then re-join the computer to the domain.

Also, make sure that if you want to apply a GPO to a computer, that the computer is in an OU where the GPO is linked to.
 
Should I rename the machine? I'm going to install service pack two on it and then try to get it back on the network.
 
No. There is not need to rename the machine. Just remember to delete it from the domain (delete it from the DC - Active Directory Users and Computer). Then re-join to the domain.
 
Back
Top