Got the old dell going but having issues

Joined
Aug 25, 2006
Messages
4,014
It is an Inspirion 2400 with XP just freshly installed. I have not done anything, no going online to download chipset drivers or anything. When I had the hard drive and cd-r on the same ide cable it would bootup just fine. I put the cd drive back on it's own cable/ide slot and now on every powerup it freezes with a double beep and says Primary drive not found(my hard drive). I have to hit f1 to continue and it loads XP just fine or I can hit f2 for bios setup.
 
Do you have the HDD on the Primary Master IDE connector and the Optical Drive setup on the Secondary IDE connector?. Jumper setting set to master on both drives?
 
When it worked they were on the same ide cable, not they are on seperate ide cables. The hd is set to primary and I have tried all settings on the cdr
 
Try setting the jumper on the hard drive to cable select or no jumper. Have a look at the jumper diagram on the drive. I've seen some drives that had no jumper if they were a master with no slave. It just depends on the brand of drive. The optical drive should probably be jumper-ed as Master or Cable Select. I set all my drives to cable select and use the IDE connector to determine master slave.
 
The cdr is shown in my computer and I assume it works, but it's annoying having it pause up every restart until I hit f2
 
Back
Top