Gigabyte Board Problems (Maybe Memory)

nightshark

n00b
Joined
Nov 7, 2009
Messages
4
Hello all,

I built a PC about a year and a half ago. Specs are as follows:

Gigabyte GA-EP35-DS3L
Crucial Ballistix PC2-6400 1Gb x 2
Intel e2160 1.60 Ghz processor
Asus EAX1550 Video Card
Antec Earthwatts 500w PSU
Some LiteOn Dvd-RW drive
Western Digital Blue 640Gb HD
Western Digital Green 1Tb HD
OCZ Vanquisher CPU Cooler
Antec Sonota III Case

I had been running a stable overclock at 3.0Ghz for many months and experienced many BSOD in Vista. It was bad RAM and I RMA'd it. Then a few months pass and the board crapped out and RMA'd that. It lost the bios....something I've never experienced. Gigabyte reflashed the board and sent it back. I have since then installed Windows 7 Professional and I am having similar problems. I thought maybe it was my overclock so it now runs at stock, but the problem persists. I also thought drivers, but all are as current as can be. Now the board will not post unless I reset the CMOS. Sometimes it will boot with one of the Crucial sticks installed, sometimes both, but usually not. It has been running fine on some plain old Samsung memory (512mb) on stock settings. Very slow though! This led me to believe it was the memory again, but MemTest ran for many hours with no problems. I have MiniDump files available if someone might want to look through them. I have also called Crucial and the tech said my system might be overheating and to install more fans and my PSU is not enough for the system. He said the Ballistix Ram needs 160 watts. I don't think this is true. Can anybody please help point me in the right direction. This is becoming very frustrating and I don't know what to do next. Is the board crapping out again, bad RAM, dead CPU or PSU? I am at wits end as this has been going on for almost as long as I've had the system. Thank you.
 
Didn't notice the sub-forum. This should probably be move to Intel Motherboards. Sorry.
 
What are the ram timmings? What voltage are you feeding the ram?

Sometimes backing down the timmings and lowing the ram voltage can clear up ram instability.

Example, 5-5-5-15 at 1.9v

Other things to check are the power supply. Your Antec should be good enough, but that does not mean you could have got a bad one.

That's about all I can think of right now.
 
So far it seems stable with the relaxed timings, speed set to auto, and no overclock. The RAM voltage is still 2.0 though. If it crashes again I will reduce it.
 
Back
Top