Giant P4 Heatsink > *

Seem's you might get better air flow if you rotated it 90 degrees clockwise, so that the
sink fan is blowing in the same direction as the large rear exaust fan.
 
kuyaglen said:
Seem's you might get better air flow if you rotated it 90 degrees clockwise, so that the
sink fan is blowing in the same direction as the large rear exaust fan.

im sure it's heavier than 600grams. The review i saw on it wasnt too bad. Comes with a real quiet fan but you can setup a nice Push pull if you notice!!!
 
kuyaglen said:
Seem's you might get better air flow if you rotated it 90 degrees clockwise, so that the
sink fan is blowing in the same direction as the large rear exaust fan.

Nope, its a one way type deal. Abit IC7-G has the socket the "wrong" way. Meh. System stays cool enough for me. I'll throw a blower down above the graphics card when i replace it with something hotter.

The key about this heatsink is it gets pooped on for being a hard install, but it doenst get near the acolades that it should for being dead silent (especially throttled by the Abit board to 60%) and scaling incrediably.
 
Back
Top