Gateway FHD2400 & boot-up text

mikeelmy

n00b
Joined
May 5, 2008
Messages
2
I have the Gateway FHD2400 24-inch widescreen LCD monitor. The monitor that I replaced uses DVI and I can see the text that is shown at boot-up. The Gateway will not display the text (using DVI) from boot-up. It seems that the problem is with the monitor and not my ATI video card since my older DVI monitor will show all the startup text. Is there any way to tell the Monitor (and video card) to just use DVI all the time? The reason I would like to see the text at startup, for example, would be to get into the BIOS or boot a different operating system. My video card is an ATI ALL-IN-WONDER X800 XT.

Thanks.
 
No it does not. I did also hook up the VGA. The only way to see the text, at this time, is if I switch the monitor to VGA during startup.
 
I had the same problem with my gateway 19" WS LCD. I had the x800pro. I couldn't see the bios with that card or anything else unless it was VGA. No start up text, nothing.

I had to plug in another crt monitor to get to see boot up and stuff.

It's the monitor and your gpu combined. Gateways don't want to show anything until boot through DVI on the x800 cards.

I don't think there is a fix and I know I still don't see post information when I plug my old gateway into my old computer with the x800 in it.
 
Back
Top