• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Front USB/headphone/mic jack problem

D

Derekh

n00b
Joined
Feb 8, 2004
Messages
33
Im trying to connected these from my raidmax case to my Asus P4P 800 Deluxe, anyone have ANY idea where you put the lil 1 pins into? They say like, MIC1, GRND1, GRND2, USB1, ect... one set has 5, one set has 4, and another set of 1 pins has 4

Where do they go on the mobo? Read the manual and looked with a magnify glass, couldn't find anything

Derek
 
I had to go to my case manufacturer site to translate what was listed on the leads to what I connected to on the board. Check in the manual for the explaintion of the pin headers for usb and audio.
 
hmm.... my ABit mobos (both of them) had a nice drawing showing what went where -- only slight translations were needed (grd = ground, etc)
 
I have the same mobo and for the usb ones there should be 4 plugs for each usb port. It says it in the manual which goes where, just needs a little interpretation. Also, my case came a hole for firewire but no firewire cable, any idea how to get one? It wasnt intended to be included either
 
If I remember right, for each USB port there is a 5v+ a Data + and Data - and a ground. Then there's usually like a single ground that both of them share also. I had to do some interpreting to match the ones on my Antec to my motherboard. Usually have to figure out what wires are which from the case, and then which pins are which on mobo, then matching them up.
 
You must log in or register to reply here.
Back
Top