Fried mobo?

Grnade

n00b
Joined
Aug 27, 2004
Messages
10
I recently purchased an Antec 350W power supply to replace my old generic 300W. After replacing the power supply with the new one I fired it up but got no screen. Fans started, lights were on, just no screen.. so I was thinking POST error. I double checked my connections, they all seemed fine. I knew I had disabled my on-board sound, which my mobo (ASUS P4B533) uses to alert me of any POST errors. So I decided to reset my CMOS through some jumpers. After that was done, I plugged her up and got nothing. No lights. No fans. Not even the power supply fan. However, when the power supply is turned on, I do get my motherboard light, which makes me believe that the mobo isn't fried. I've checked the wiring for the off/on case switch to my motherboard. I double and then triple checked all the connections, and unplugged IDE devices just for now. I even took my old power supply and hooked it up to my mother board, same result.
My old power supply only needed to connect the 12V (4 pin, square shaped) and ATXPOWER (20 pin) power cables to the motherboard, however my motherboard does have another 12V(4 pin, in a row) which I assume is for power supplies without the standard square connector. I didn't plug the second 12V connector in because I assume the other one takes care of it. Since I got the mobo light, I assume power to the motherboard is good.

Does it sound like I fried my mother board in the process of replacing my power supply? Any suggestions/experience is welcome..
 
Did you try a different psu cable that goes to the wall outlet? Maybe it got fried when you turned it on.
 
No, I didn't, but my PSU cable is connected to a backup UPS that I thought was supposed to prevent that kinda thing from happening..
 
Fanatik said:
Did you try a different psu cable that goes to the wall outlet? Maybe it got fried when you turned it on.
Your kidding right? Obviously this could not be the problem since the machine it getting power.

Put your old power supply back in and see what happens. Always default to a known good situation if you can.
 
CentronMe said:
Your kidding right? Obviously this could not be the problem since the machine it getting power.

Put your old power supply back in and see what happens. Always default to a known good situation if you can.

He already tried that same thing. Yea the machine is getting power but how much?
 
i'd take the board out of the case try it with only a vid card and power hooked up and see if u have vidio then.
 
Back
Top