• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

fortiwifi help

A

AP2

[H]ard|Gawd
2FA
Joined
Jun 25, 2007
Messages
1,570
currently im trying to reconfigure my firewall (fortiwifi 60a) so that my WLAN is on the same subnet as my Internal network. I would like see whats on my network when i connect wirelessly.

anyhow im currently running firmware: FortiWiFi-60A 3.00-b0744(MR7 Patch 6)

im able to combine the 2 interfaces, by using the following CLI

config system switch-interface
edit (new interface name)
set member internal wlan
set vdom root
end

when i check the network tab, my newly created interface (wlan+internal) shows no uplink or down status. am i doing something wrong?

the policy i have set is new interface (wlan+internal) to wan1 and accepting all traffic. still cant get out though :(

any advice would help! if theres anymore info i can provide let me know.
 
The up link status is fine.
Go to the firewall tab and make sure you have a policy to allow for each direction of the interfaces you have.
Is your wlan getting an IP?
 
my computers/servers connected hardwired receive a 192.168.1.xxx and so does my wlan.
as soon as i get home ill check the policies again.

thanks for the help.
 
sorry forgot about this threawd :(

yes i have NAT enabled and i do have LAN (internal+wlan) to WAN1 policy.
 
Do you have a policy set for your WLAN to talk to your LAN and vice versa?
Can you ping the gateway when connected to the WLAN? Can you ping anything on the LAN?
 
You must log in or register to reply here.
Back
Top