• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

First attempt on a serious OC *need tips*

G

Ghost$nipa

Limp Gawd
Joined
Jul 27, 2004
Messages
227
Hardware:

E6600
Abit Fatal1ty in9 650i chipset SLI
Kingston Hyper 5-5-5-18 (1066 rated speed) 2.30 V
250 GTS
BFG 650W PSU

If i touch the multiplier it wont boot peroid. Left it at stock "9".

PCI set to 33.33 and PCI-E set to 100

E6600 at 1.412 V OC to 3.4 speed 378x4 @1512
Temp at Idle 51C MAX load at 63C

Currently using Unlinked mode....If I use sync, dividers or linked it forces a lower OC.

NB voltage from 1.2v to 1.43V

Memory at 2.30 volts with looser timing of 6-6-6-22. Speed currently at 520x2 = 1040 speed.

I noticed that the memory can't run at it's rated speed timing so I was forced to loosen the timing. I haven't tried to focus on lowering the memory timing.

Anything lower with voltage will either crash before boot or prime fail. I tried to lower all voltage such as CPU, VTT and NB....what else can I do? I could install some small fan on NB and use some silver paste on all silicon chips?

I am trying to save some money and skip out on the current platforms until I am ready to upgrade.
 
You must log in or register to reply here.
Back
Top