Finally OC'd My Athlone 64 3200+

SuddenDemise

Limp Gawd
Joined
Feb 21, 2005
Messages
361
Overclocked my Athlon 64 3200+ to 2.3. Not a big step, but its my fisrt OC But I had a question about my memory. I have a 512 Stick and a 256 Stick of DDR400. Since my OC my bios says my memory is running is running at 110MHz. Shouldn't be running faster then that. I was told when you up your FSB your memory matches that speed. So shouldn't my memory be running at 230 as well? or have i been misled?
 
It looks like your memory is running on a divider. Look in the BIOS for this setting and fix it to 1:1 if your memory can handle it.
 
In the bios it will be under cell menu. Go to DRAM config and set it to 200. By the looks of it its on 100. Should give ya a nice performance boost jus by doing that
 
Set the divider to 5:6 yeah, thats the 166 setting in the dram config menu. I dont kno what memory or cooling your runing. But im pretty sure most generic mem will run 210Ish with a little more juice. Just loosen the timings some. With a 208Mhz memory clock, and 5:6 ratio. You will have a rather chirpy 2.5Ghz A64. Jus remember to feed it a few more volts. I had to up my CPU to +3.3% over volt to get stable at 2.3, And just incase i run into any stability problems i put it upto +5% over volt for the 2.5. By using the dividers and stuff, you can keep your memory running at a stable full speed (or just over) and get some crackin speeds!
 
Back
Top