Fan headers don't work

’m‚³‚ñ

Supreme [H]ardness
Joined
Jun 20, 2003
Messages
7,300
I have an old board (Slot 1) that I was setting up as a F@H boxen. However, the fan headers do not work. Since I'm goign to be using a Quantum SCSI drive in this, and this sucker gets HOT, I went about putting some fans in the case. However, neither of the two fan headers appears to work... So, is this board bad, or should I just suck it up and wire the two fans into molex connectors/the fdd power?
 
plug em in with 3-to-4 pin molex connectors...better for your board anyway as it demands less power from the board's electronics =)

svc has these connectors for $.49 to $.99 depending on flavor you like =)
 
Originally posted by Angry_Games
plug em in with 3-to-4 pin molex connectors...better for your board anyway as it demands less power from the board's electronics =)

svc has these connectors for $.49 to $.99 depending on flavor you like =)

Oh, I forgot about this thread.

I figured out that none of my headers are broken at all; both of them work just fine. I needed to use fans with the third wire (RPM) for the header to get power. :p So it's all good. ;) Except, now I need to find a heatsink for my SCSI drive... It's on the verge of overheating. :(
 
an enclosed cooler is pretty good but not sure if it works with scsi drives (ive seen some odd-sized scsi drives and never owned one myself tho lol).

most of the hdd coolers other than enclosed ones like a Hardcano are crap and rattle like an old jalopy =/
 
Originally posted by Angry_Games
an enclosed cooler is pretty good but not sure if it works with scsi drives (ive seen some odd-sized scsi drives and never owned one myself tho lol).

most of the hdd coolers other than enclosed ones like a Hardcano are crap and rattle like an old jalopy =/

Yeah, I'm probably going to use a rubber band and some AS3 on a PIII cooler. :p It's worked for me so far.

My SCSI drives are standard drive size so far. I might be getting some 1.6 inch tall drives though... I'm going to have to get some adaptors for those, I'm afraid. :( Won't fit in my hot swap bay. :(
 
Back
Top