Exposing the NB core

dobbz

Limp Gawd
Joined
Sep 4, 2002
Messages
339
i been looking all over for this pic i saw but i cant find it.. ill look in my IE cache.

anyway, it was a shot of a northbridge with the heatspreader pulled off and it looked just like an Athlon processor but with a smaller core and few little resistors peppered around the surface, and i think it was on a P4 board. how can i get the heatspreader off my DFI NB and expose the core like that? i dunno what the point of heat spreaders is anyway, so if this is a bad idea lemme know.

the reason i want to try this is because the heatspreader is badly concave. i noticed it after removing the NB sink to lap it and apply AS5. not only does the speader touch nothing but the very corners of the lapped NB, but i layed the edge of a credit card along each side, diagonally too, and i can see a gap in the center quite clearly. i tried for almost an hour to sand the edges with 600 grit sand paper but all its doing is smoothing the surface of the spreader.

the board is a refurb, but the FSB goes to 245 stable, +5 over my old DFI that i fried, and i see no other issue at all with it so id rather get through to the NB core if its possible.
 
nforce 2 northbridges are not flip-chip.

cores on intel northbridges are flip chip, but have no headspreaders and do have exposed cores:

845pe.JPG
 
oh ok. welp..

what do you think i can do to get the sink seated good, besides use a huge glob of paste? the bottom of the socket was too hot to touch more than a couple seconds, while the sink never even got warm. the AS5 doesnt seem to help much either.

well, not the socket but the underside of the board where the NB is attached.
 
sucks man, get a better nbridge cooler like the swiftech and just use extra as5.
 
a new cooler huh. i dont think it would help since the way the sink sits, it doesnt even get hot anyway. i guess ill have to live with a 245 FSB. :p its prolly just the memory's max anyway.
 
Back
Top