Expanding ESX cluster - join to storage first?

Joined
Nov 3, 2010
Messages
2
Hi guys,

I have a question - at the moment we are running a pair of Dell R900s clustered with ESXi 4.1, with an EMC Clariion CX3-10 FC SAN at the backend. I'm about to add an extra host to the cluster (an R710) - I have enabled EVC, but I'm wondering - do I need to add the host to the ESX cluster before connecting to the storage, or do I connect to the storage first then add the host to the cluster?

Any ideas?

Cheers

JD
 
Doesn't matter. It's not uncommon to have hosts see some different storage..doesn't cause an issue. The cluster knows it can't move a VM to a host that can't see the datastore.
 
IIRC if you add it to the cluster, and the WWN of the HBA in your new host is in the initiator group on your SAN it will automagically add the datastores, no?
 
IIRC if you add it to the cluster, and the WWN of the HBA in your new host is in the initiator group on your SAN it will automagically add the datastores, no?

I think it rescans the datastores when you add it..but if not that's a 2 second process. Doesn't matter if you zone the storage before or after it goes in to the cluster.
 
If you haven't already loaded ESXi, don't forget to keep it off the SAN until the install is complete so you don't accidentally blow away your datastores...
 
Yeah, that's one thing I don't like about ESXi - why the hell does it do that? Admittedly it should only do it on local storage, but seeing as it can't tell the difference sometimes (like the H200 PERC in my new R710 it thinks is remote storage...) it's a tad worrying.

I'm pretty sure when Dell set up the Clariion setup initially they had it set to open zoning, so I should just add the host and all will be well, as there will only be 3 hosts I'm happy to run it like that, unfortunately it's a production cluster so I can't really take it down to start messing about with zoning :(

Hellraiser........>
 
Back
Top