eView 17f3 cable end gone

[BinarySynapse]

I have an eView 17f3 monitor that has had the end cut off. I want to put a new end on it as it would be cheaper than a new monitor. I have absolutely no idea which wires go to which pins in the connector. The old end doesn't have enough cable left to trace them so that's out. I was wondering if somebody knew what the wire colors might mean.

there are 11 wire going into the monitor to two conectors with the following colors:
Connecort 1 (CRT board)
1- bare
2- Gray
3- Bare
4- Pink
5- Bare
6 - Light Blue
^(22awg wires)

Connector 2 (main board)
1- Yellow
2- Brown
3- Green
4- Orange
5- Black
^ (24AWG wires)

Wire sheild is grounded chassis using a spade connection.

I think that Pink = pin 1 (Red), Grey = pin 2 (green), and LB= pin 3 (blue) on the DB15HD connector. and that the bare wire are the signal grounds for pins 6 7 and 8. but I don't want to assume and I still have no idea what the other colors may be. If someone could help to figure these out I'd really like to get this fixed.

Thanks
Ryan


PS I believe this a Proview 786N monitor since there is a Proview label inside the plastic case and the model no on the label says 786N, but I could be wrong. I've also googled for replacement cables, and schematic to no end, I can't find anything.that's helpful.

 

[BinarySynapse]

for those who may need to know in the future. I've figured out the wires for this monitor
it an eMachines 17f3 model 786N made by Proview.

there are 11 wires going into the monitor to two conectors with the following colors:
Connector 1 (CRT neck board)
1- bare - Green return - Pin 7
2- Gray - Green signal - Pin 2
3- Bare - Red return - Pin 6
4- Pink - Red signal - Pin 1
5- Bare - Blue return - Pin 8
6 - Light Blue - Blue signal - Pin 3
^(22awg wires)

Connector 2 (main board)
1- Yellow - VSync - Pin 13
2- Brown - HSync - Pin 14
3- Green - DDC Data - Pin 12
4- Orange - DDC Clock - Pin 15
5- Black - Ground (DDC return) - Pin 5
^ (24AWG wires)

Pins 4 10 11 - Ground
Pin 9 - N/C



Ryan