EVGA Classifed can't reboot

cleiomar

n00b
Joined
Apr 9, 2010
Messages
29
I have a classified e761 brand new from rma. The problem is when I want to reboot the board turns into a reboot loop.... when i change a setting in the bios it reboots but after 3-4 seconds the board switches off, reboot again 3-4 seconds later off again, and so on and so on. When I remove the power cable and plug it back in it will start and load windows but I cant reboot after that, I have to remove the power cable if i want to restart? Can someone help me?

Info:

i7 930 @ stock
GTX 260 MaXcore
EVGA Classified e761 (latest bios)
700W OCZ Fata1y
4GB Corsair XM3 1333
 
do you have an extra psu you could test out? if thats not the cause then ya might want to start up another RMA..
 
So far I've tried the following to no avail.

A different PSU
Alternating ram sticks
Setting up the motherboard outside the case
Loading default bios settings
Updating bios
 
may want to contact EVGA.. looks like you've pretty much checked everything..
 
Why would you waste your money? Just call them, sound angry, bitch & raise hell, then ask for an RMA.
 
dont sound angry, be angry. sounds like they sent you another bad board. i like evga, but for what they get for the classifieds you would figger they would go thru decent qa. was it a new in box board from rma?
 
What is the POST code showing? (just for completeness, because the evga guys will probably ask that)

Let me see if I understand, if you unplug the PSU and plug it back in, the machine will boot up and run properly?
But if you restart it, it goes into a continuous reboot cycle?

Did you reseat the CPU?
Did you remove the battery after unpluging the PSU?
Did you try all the RAM individually in the slot farthest from the CPU? same in slot one?
Is the RAM VCore set at 1.65V?

I suspect your "new" board is FUBAR.....and you'll need to RMA it, and I feel your pain.
I had the same issue on my first EVGA X58 SLI board. Dead right out of the box.
Trust me, when the RMA came I sweat bullets, and did the same when I traded up for my Classified........so far I couldn't be happier with my Classified, now over 1 year old and running rock solid.:D

On further review.....you have a Classified with triple DDR3 correct? If I'm not mistaken, you need to be pretty careful about how you populate the RAM slots, in the manual for 4GB of RAM, populate slots 1 and 3 (those being the RED slots closest to the CPU).....that might be the deal.
 
Last edited:
I had the exact same issue with my evga board and it was a faulty surge suppressor at fault, believe it or not. Plugged it in the wall and she worked fine.
 
Back
Top