DVI and westinghouse

I

illuminate

[H]ard|Gawd
Joined
Nov 24, 2007
Messages
1,895
I have this monitor. today i bought a DVI cable to go from my 7600 to my monitor. when i plug it in... nothing happens. i change the signal to digital, still nothing. any ideas?
 
Did you try to start your computer on safe mode? It might be your graphic card set in wrong resolution (higher). Try reinstalling your display driver.
 
no, i checked. its set at 1280 x 1024. and that is the exact res. of my monitor.
 
Your VGA works, but not your DVI? Try the input selector at the front? Also there's different DVI cable and I hope you didn't get DVI-A which is analog only. Yeah, I don't know what else to come up with. Sorry.
 
where would an input selector be? Im my monitor control panel? ive checked there. that is wher ei switch from analog to digital
 
Yeah. ok. i found it. it was what i was pushing before.. but it still sint working. any other suggestions?
 
You must log in or register to reply here.
Back
Top