Drive cages, where to get?

  • Thread starter Deleted member 12106
  • Start date
D

Deleted member 12106

Guest
I am looking for some drive cages for a project. Not the hot swap type, not the ones that get mounted inside of a 5.25" drive bay. Typically, the ones that go inside of cases. I have an old full tower case I'd like to mod.

Basically, I am after something like http://cgi.ebay.com/Hard-Drive-Moun...3286.c0.m14&_trkparms=66:4|65:1|39:1|240:1318 Not after anything crazy.

Basically, I want 4 that can hold 5 drives, and I can lay them sideways in my case, in the front, and mount them to the case internally. Ideally, something that could hold 2 80mm fans would be great.
 
As an eBay Associate, HardForum may earn from qualifying purchases.
Anyone knows where to get this in the EU? The email address I got last time didn't work, fella didn't reply.

Thanks much.
 
Well, I decided at buying 3 of those for this project, it would make it expensive...

So....I went to Menards and bought some stuff...

no%20020%20%5B640x480%5D.JPG

Results of some elbow grease...
no%20023%20%5B640x480%5D.JPG

Set in the bottom of the case...
no%20024%20%5B640x480%5D.JPG

The 3.5" bays that I will be taking out tomorrow.

So far, I am at about $25 in misc. parts. With this setup, I can add 18 drives in this configuration, then add in my sata back plane to the 5.25" bay, and get 21 total bays.

What I bought:
8x 3x7" ties
2x 1/8" drillbit.(needs to be slightly larger)
Misc screws
6-32x36" threaded rod. This will be used hopefully to tie each "rack" together and screw through the bottom of the case.

I am going to also mod the front of the case to fit 80mm fans, goal is 2x fans in front of each "rack". Then, I plan to add in a 120mm fan in the back, one rated at 190 CFM. Not too worried about noise, where I am putting it will make it a whisper of air. Here is where it will chill out.

The thing that is going to suck is replacing and adding drives, but, it would have sucked with the $30 brackets.
 
Back
Top