• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Drill bits

N

Nyarlathotep

n00b
Joined
Aug 10, 2003
Messages
52
Can anyone tell me what type of drill bits I should use to install 2 120MM window fans and 1 120MM blow hole?
 
the round kind. depends on the material your cutting actually. realisticlly you can just use a normal bit and vary speed depending on material as in slow for plastic fast for metal but honestly if your going to cut metal you might want to get some re-enforced bits becuase you may jack up your normal bits. thats for the screw holes. for the fan holes use a holesaw. its just a huge round teethed drill bit. you can find them at any harware store. find the right mm size is hard though. 120 mm = ~4.7inches. you will find sizes all around there but probably wont find 120mm specifically. +- about .25 isnt that bad. i use lenox. its tought and works.

BLADE
 
You must log in or register to reply here.
Back
Top