• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

dremel question....

A

Atherton213

[H]ard|Gawd
Joined
Dec 21, 2004
Messages
1,863
ive got a dremel... and i wanna put a spot for another fan on my case... do those bits that cut large holes work in a dremel? or would i need a normal drill for them

also if so... (i know this was said somewhere) what size bit for 80mm fans
 
Hole saws would not owrk in a dremel... if it didn't lock up the dremel itself, it would rip your arm off because you dont got anything to grip on.

Your best bet would be to go out and buy a real drill.
 
Dremel plastic, drill metal.
I use a 3 1/8 or 79 MM for cutting 80 mm fan holes.

drill.jpg


Hope that helps.
 
Damn it! F'ed my drill up today cutting into a server case....had to dremel those fan holes...

dt001.jpg


But it's done...27 plus inches tall, with windows on both sides...
 
Full metal, if you put a center bit in that hole-saw of yours you'll probly get better results... just an idea.
 
Sounds good. Thanks. I have always been into tweeking inside of PC's, the out side mods are new to me.
 
Punx_Clever said:
Full metal, if you put a center bit in that hole-saw of yours you'll probly get better results... just an idea.
Click to expand...
Geez, duh. I just realized what you said. Yes I do use one always. It is not the pic though huh. Hehe.
 
You must log in or register to reply here.
Back
Top