Disable various things you aren't using in the BIOS?

’m‚³‚ñ

Supreme [H]ardness
Joined
Jun 20, 2003
Messages
7,300
I've gotten in the habit over the years of disabling things in my BIOS when I'm not using them, Example being a Floppy drive. I don't even have a FDD anymore, I have the controller disabled in my BIOS. COM ports, printer/parallel ports, etc.

Now, my new mobo supports disabling 2 of the SATA ports at a time, so I can disable SATA 1-2, or 3-4, or all of them. Would there be any benefit to disable 3-4, since I'm only using 1-2 right now?
 
I have always done that as well....to save "resources". I don't know how much overhead it actually frees up if any though. Probably free up some IRQ's, but that probably doesn't even matter anymore.
 
’m‚³‚ñ said:
I've gotten in the habit over the years of disabling things in my BIOS when I'm not using them, Example being a Floppy drive. I don't even have a FDD anymore, I have the controller disabled in my BIOS. COM ports, printer/parallel ports, etc.

Now, my new mobo supports disabling 2 of the SATA ports at a time, so I can disable SATA 1-2, or 3-4, or all of them. Would there be any benefit to disable 3-4, since I'm only using 1-2 right now?


I always disable devices not used. The reason is more shared I/O resources that IRQ's, I/O resource sharing really takes a lot of cpu time, causing lower frame rates, unstable network connections, stuttering in video playback and general all around crappy performance that typically gets blamed on the device it is effecting at the time.

It was a real problem with the original SB-Live and 5.1 series...you some machines couldn't even function with DMA enabled for disk drives/CDROM's while the sound card was working unless you disabled everything not used in bios. But this was just one example of multitudes of complaints people had.

I havent noticed much lately with newer hardware but I also have been keeping unused devices disabled.
 
I always disable, serial ports, and raid controlers cause i dont run raid. I normally disable the parallel port but for some reason it seams the a8n32 needs it enabled for ACPI and the floppy drive.
 
I disable anything that i'm not using. I'm afraid it'll cause interference with my soundcard too.
 
That reminds me why I started in the first place. I remember having issues with a sound chip and my AGP video card sharing an IRQ, which caused some problems in games. Moving to a sound card, and then moving my NIC proved to be the solution to my problems.
 
’m‚³‚ñ said:
That reminds me why I started in the first place. I remember having issues with a sound chip and my AGP video card sharing an IRQ, which caused some problems in games. Moving to a sound card, and then moving my NIC proved to be the solution to my problems.

Believe it or not, the sharing of IRQ's was not the problem, it's I/O resources.

For example: My gaming machine has the virtual IRQ 18 shared between my 6800GT and my X-Fi and I don't ahve any problems.

Most machines in fact have shared IRQ's but the OS and hardware ACPI support creates virtual IRQ's to completely get around it. It's the I/O sharing that doesn't work so smoothly which is also something not apparently evident simply by looking at address ranges, they just cover such a large range it's almost un-decipherable.

Just go with the common proven methods: Disable unused devices and your system will run better.
 
Back
Top