Did I kill my system? (It keeps resetting quickly)

CurrentlyNotHere

Weaksauce
Joined
Jul 23, 2006
Messages
105
I finished putting together my 2nd machine last night and there is a serious problem. Every time I actually plug in the power cord in the back of the PSU the system automatically powers-on and then keeps resetting. (no need to press the power button even) Keeps resetting several times per second until I unplug the cord. All the fans keep revving up, and down, monitor keeps shutting on and off really quickly, the lights on my front temperature monitoring bay (AeroGate II) keeps flashing really fast.

The only new thing in this computer is the video card. All of the other componets come from my old (working system). I tried unplugging all the devices (from internal power cords), except the two cables for the motherboard, but same happens. I'm affraid if I keep doing these tests I will kill my system. (Unless its already dead) I mean, it resets like 2-3 times per seconds. (The hard-drive keeps spining up and down)

Only thing I can think of is that I might have scratched the mobo on the back, but I don't think it's that serious (the scratch) Anyone have any ideas?

(btw, I reposted this thread in this sub-forum since it is more appropriate for it. Mods, you can delete, merge, or lock that other one. I apologize.)
 
The scratch could have caused some problems, but some things to check first.

Make sure the power switch is connected to the mobo header correctly
Check to make sure the ram is seated correctly
You may want to clear the cmos as well.

If none of that works I would pull the mobo and have a look at the scratch on the backside, and see if it went through any of the printed circuits. If so, that could be your problem.
 
Yep, I found out what it was. After nearly two hours of troubleshooting, I tried a different power cord for the PSU, and it worked. I've had lot of things go bad on me, but never a power cord. It looks just fine, but for some reason it was the cause of all the problems.

About the scratch. It did go through some printed circuits. I traced them back to the front microphone pin-outs. I have no microphone to test this functionality right now, but the system has been working just fine, for hours. I've been running Hot CPU Tester Pro and other benchmarks and/or stress tests since I got the system to power on, and no problems so far. Maybe the scratch was not that deep. ( Although the scratch does look like it cuts through at least two circuits)

Should I just RMA this board for safety's sake? Anyone have any experiance with this type of damage?
 
Back
Top