Dfi nf4 s939 wont post/boot

[Specialist[X]]

havent been here for a while. i posted first on the dfi boards hoping to get more familiar scenarios, but now i just want as many inputs as possible.

link to thread:

http://www.diy-street.com/forum/showthread.php?t=82524

thanks for your help! all suggestions greatly appreciated. btw, yes extended cmos clear has been tried, but no luck.

 

[ilikecake]

I have not had the same problem as you, but I have had problems with this board that prevented it from POSTing properly. A few things to try/check:

• Verify that there are four power cables plugged into the motherboard (main ATX, 4 Pin P4 cable, 4 Pin Molex, Floppy power connector)
• Reseat the graphics card/try the graphics card in the other slot.
• Check that your memory is getting enough voltage.

The board is supposed to be picky about power supplies and memory that will work in it. I have never had a problem with it in that regard, but if you can, you may want to try a different brand memory/PSU just to see if that helps. It would probably also help if you list all the components in your computer.

 

[AMD_RULES]

Try a different power supply.

 

[Specialist[X]]

just bought the corsair tx750 though...