DFI LanParty Question

cvfd1615

Gawd
Joined
Jan 23, 2006
Messages
669
Hey,


I'm having a problem with my MOBO!

I can't seem to get my Secondary IDE to work or detect anything.

Not sure whats wrong with it - Primary works fine along with SATA on the mobo but can't get secondary to do anything... Bios says NONE and I'm lost on what to do.
 
is it on AUTO? are you sure its enabled in the BIOS? Did you try another cable? are you sure the power is plugged into the drive? are you sure the PSU is ok?
 
OK its IDE 1 that isn't detecting anything... I have tried to move it to cable select, master and slave and it still detect anything.

I have it set on auto and then I also push it to detect stuff and it still comes up with nothing... I've made the sure the DVD rom is plugged in, Made sure the cables are connected securely and I still get nothing to work on IDE 1 anything else to do?

PSU Is ok w/ no problems and I've tried 2 cables.
 
Make sure you have a drive detected and working on the known good IDE channel, and then just move the cable over. If the drive doesn't detect, then you know the problem is indeed that IDE channel, and not misconfiguration.
From there, I'd try clearing the CMOS.
If the problem persists, contact your mobo manufacturer for support. Hopefully you'll still be under warranty.
 
Make sure you have a drive detected and working on the known good IDE channel, and then just move the cable over. If the drive doesn't detect, then you know the problem is indeed that IDE channel, and not misconfiguration.
From there, I'd try clearing the CMOS.
If the problem persists, contact your mobo manufacturer for support. Hopefully you'll still be under warranty.

I know the drive works and I've used the same cable that is working fine on IDE 2... What ya think could be wrong with the IDE1 jack

BTW, what is FDD the one that runs different on the MOBO
 
I know the drive works and I've used the same cable that is working fine on IDE 2... What ya think could be wrong with the IDE1 jack

BTW, what is FDD the one that runs different on the MOBO

IDE ports just burn out somtimes. It's really hard to say, but, the only way to fix it is a new motherboard. FDD is the floppy disk drive controller
 
I'm not having any problems with it other than that and actually don't even use but just 1 IDE port... My HD's are SATA so no biggie.


Just wanted to get it going but oh well no biggie
 
If its still under warranty, you should replace it while you can. But since its not needed, you really don't have to... but still, it would be nice to get a fully working board, since thats what you initially paid for.
 
Back
Top