DFI LANParty NFII Ultra B issues

lotus-

n00b
Joined
Mar 15, 2004
Messages
4
Just spent 6 hours trying to get my new DFI mobo to boot to install windows. I have tried several different hard drives including both ide and sata, and nothing works. I can boot off of CD, start winXP installation. Goes through the startup sequence loading drivers and right when it finishes loading drivers in the initial setup mode, I get a blue screen of death dump and it doesnt continue. This is all before I can actually get to the entering of data to begin formatting any drive and load any OS files to the drives. I have tried IDE and SATA drives, I have loaded the SATA driver disk. Downloaded new drivers for the SATA controller, and nothing works. I keep getting the Blue dump before anything starts.

Can anyone help

DFI LanParty NFII Ultra B
AMD 2800+ Barton
FSB 166 stock @ 2088mhz
Corsair TWINX Dual Channel 512MB PC3200 DDR 400MHz (2 x 256MB) Memory
GeForce ti4600 (Visiontek first release 2002)
TDK 52x CDR-w
Sony 12x DVDr
Maxtor 40gb IDE
WD 40gb IDE
IBM 80gb IDE
IBM 120gb IDE
Seagate 80gb SATA
Seagate 120gb SATA
 
if you have made a jump in processors, then you might not know that there are two places on the board where you connect power. one for the board and the other for the processor. i have noticed that if you don't have the second one for the processor plugged in, that you get far enough to think that it is going to work, but then you get the blue screen of death... check it... also, check out amdmb.com and hit up angry_games. he is paid by DFI to help you out.

post if that wasn't it

-run
 
nope, cpu power is plugged in. I sent a message to angry on other board.. hope he has some insight... Thanks.
 
Back
Top