DFI Infinity voltage probs?

HybridHB

[H]ard|Gawd
Joined
Dec 15, 2002
Messages
1,258
I just got my DFI infinity installed last week, and so far its been good. I been real busy with school so i havent had a chance to game on it alot, but these voltage ratings are kind of concerning me. Take a look.

infinityvoltage.JPG


They seem a little low, in bios the vcore is at 1.7. Just wondering if its my psu or the board? The psu seems to undervolt my old nf7-s too, but not that much. Maybe this dumb antec tp 480 is dying? It might since the leds dont even work anymore. For anyone looking into a psu, my enermax was 10x better than this pos antec.
 
....mainboard sensors are never really accurate.. So don't put much weight in it. Get ye a multimeter.
 
those are a bit low but they wouldnt affect anything
unless they start to drop dangerously low....then u got a problem...
 
Ouch - your Antec 480's voltages are just as low as my pos Turbo Link 420 watter [Channel Well Tech made] :D .. Actually mine generally reads .1v higher on the 12v line..Again motherboard sensors are notoriously inaccurate tho..
unless they start to drop dangerously low
Actually, I'd say the 3.3v line is starting to get too low.. General rule is 5% AFAIK
 
Back
Top