- Joined
- Sep 26, 2008
- Messages
- 9,315
So I have a Netgear R7000 router that I've been having a lot of problems with (mostly restarts and dropped connections). I finally decided to flash it to DD-WRT, but before doing so, I had successfully setup Wake-on-Lan on the stock firmware. It worked flawlessly from inside my LAN and from outside the network. So I know that the BIOS/EFI and network adaptor was all setup properly.
So anyway, since going to DD-WRT, the router is rock solid... I honesty couldn't be happier. I've been researching the WOL abilities of this firmware, as it's a LOT more robust/advanced than the Netgear firmware (on the Netgear FW, I only had to enable it and forward the port to the machine I wanted to wake up... In contrast to all the options on DD-WRT).
So I gave it a try and I can get the machine to wake from inside the LAN, but can't seem to get it to wake up from outside the network. I read the wiki along with some forum posts regarding configuring WOL on DD-WRT, but it was way above my head. IIRC, it says to forward the port to an unused IP (ex 192.168.1.254)... But this confuses me since the IP of the machine I want to wake is 192.168.1.2.
Also, it says that I should be forwarding port 6 (most commonly used for WOL apparently) but I'm using splashtop and it uses port 6735 (I believe). So at this point aim really confused and was hoping someone could help explain it. If DD-WRT wants me to forward the port to 192.168.1.254, how does it know which machine on the LAN to wake?
So anyway, since going to DD-WRT, the router is rock solid... I honesty couldn't be happier. I've been researching the WOL abilities of this firmware, as it's a LOT more robust/advanced than the Netgear firmware (on the Netgear FW, I only had to enable it and forward the port to the machine I wanted to wake up... In contrast to all the options on DD-WRT).
So I gave it a try and I can get the machine to wake from inside the LAN, but can't seem to get it to wake up from outside the network. I read the wiki along with some forum posts regarding configuring WOL on DD-WRT, but it was way above my head. IIRC, it says to forward the port to an unused IP (ex 192.168.1.254)... But this confuses me since the IP of the machine I want to wake is 192.168.1.2.
Also, it says that I should be forwarding port 6 (most commonly used for WOL apparently) but I'm using splashtop and it uses port 6735 (I believe). So at this point aim really confused and was hoping someone could help explain it. If DD-WRT wants me to forward the port to 192.168.1.254, how does it know which machine on the LAN to wake?
Last edited: