Corsair cmpsu-750tx question

Mangudai

Limp Gawd
Joined
Oct 2, 2005
Messages
343
I have an older nforce 2 socket A board. I was install the new psu in and I was looking for the wire that goes into this plug circled in red.


vpdcso.jpg



Since Socket A's are 20 pin would I use the +4 here?
 
Nooooo. That would fry your board (if it even fit).

There should be a 8pin "EPS 12v" connector that splits in half that will work in there.


EDIT: From the TX650/750 manual

1 x 610mm (24”) 8-pin EPS12V connector cable.
Note: The EPS12V power connector has a detachable 4-pin mechanism
in order to support either an 8-pin socket or a 4-pin “P4/12V” socket on
the motherboard.
 
Thanks a lot man. Something didn't see right about that idea, especially since Id have to cut off some of the wrap to stretch it far enough.
 
Back
Top